Integrating CAD/CAM using

Yuwono Ongkowijoyo

Mechanical Engineering 1998

This Thesis is submitted in partial fullfillment of the requirements for the award of
Bachelor of Mechanical Engineering
from
University of Wollongong

 

Aims:

To design and implement an enhanced system for effectively integrate the highly capable CATIA software and advanced manufacturing technology located both on and external to the University of Wollongong site.

 

Methodology:

  1. Research (Literature Survey) modern CAD/CAM systems to identify remaining key problems and trends.
  2. Gain familiarity with available hardware CAD/CAM (CATIA software).
  3. Use the CATIA software to design and produce range of parts. Including converting the design to NC verification.
  4. Develop interfaces to new equipment on off site.
  5. Use CATIA for off line programming of off site manufacturing operations.

 

The report of the Thesis is summarised in the topics follows. Please click the title of the topic to browse.

Table of Contents

1. Acknowledgement

2. Abstract

3. Introduction

4. Literature Survey

5. CAD

6. CAM

7. Methodology

8. Results and Conclusion

References/Bibliography

[email protected]